ProVape : Avis et questions sur votre commandePanne Ao 1,3

Section réservée aux avis, feedbacks et questions à propos de vos commandes chez ProVape.
Règles du forum
Dans cette section, vous pourrez nous faire part de vos impressions suite à votre commande chez ce revendeur, et nous donner votre avis sur les produits de la marque.
Pour rappel: le Forum n'est pas le lieu adéquat pour le règlement de conflits entre vendeurs et clients qui doivent l'être par le biais des moyens habituels (téléphone, mails, courriers...). Toute tentative d'utiliser le forum pour régler des contentieux du domaine privé sera sanctionnée.
Avatar du membre
drovich
Cirrus
Cirrus
Messages : 2136
Enregistré le : jeu. 15 avr. 2010, 18:38
Ecigarette (s) utilisée (s) : Istick Pico
Cyclone AFC Vicious Ant
Serpent RTDA
Ammit 22mm
King Tobacco Fifty
Absinthe rouge VDLV
Localisation : Annecy (74)
Genre : Homme
Âge : 50

Re: Panne Ao 1,3

Message par drovich » dim. 11 déc. 2011, 18:49

Heureusement il me reste des batteries EGO...
Demain je vais essayer la manip conseillée par Provape sur leur site dans ce cas (nettoyer l'intérieur en mettant de l'alcool 99%, secouer et laisser sécher). Etonnant sur de l'électronique mais comme ils le conseille... :oops:

Original ci-dessous :

If you accidentally spilled lots of juice on the ProVari and it has run down the side and in through the button location or window area, it's possible some juice got inside the device.

This can cause random error messages that you didn't see before or if all of your atomizers and cartomizer are reading 1.3 ohms or any other strange behavior, you might need to clean the unit.

Please note: the top cap of the ProVari is sealed so typically juice will not get into the unit from the top.
We have had users report that they were using a tank and it leaked along the side of the device, this is the situation most likely to cause juice leakage into the ProVari.

This is a very easy procedure:

1. Remove the battery

2. Using some 99% isopropyl alcohol, pour a small amount into the tube so it goes down where the circuit board sits.

3. Gently shake the device so the isopropyl alcohol swirls around inside the tube.

4. Now pour it out and let the unit dry.

5. It's important to let it dry completely before installing the battery again.

It's a good idea to leave the end cap off and leave it overnight to dry. Then try again.

If you cannot find 99% isopropyl, you can use 91%.
91% has more water, so it will just take a little longer to dry.
Ma HIFI :
SBT Fidelity Audio #2 - KINGREX Psu Mk2 - WW Gold Starlight 6 coax
TEAC UD-501 DAC - VOVOX Textura
AUDIOMAT Opéra Référence - MOG 2919
KEF R900

Image

Répondre

Retourner vers « ProVape : Avis et questions sur votre commande »