Les mods électroniquesProteus, le GG électronique (par Imeo)

Avatar du membre
Patricko
Altostratus
Altostratus
Messages : 19951
Enregistré le : jeu. 26 juil. 2012, 02:54
Ecigarette (s) utilisée (s) : Tubes Méca / Box BF méca / RBA / RDA / Genesis / DIY
Localisation : Bruxelles, non peut-être...
Genre : Homme
Âge : 60

Re: Proteus, le GG électronique (par Imeo)

Message par Patricko » lun. 6 juin 2016, 00:29

phpBB [video]
Image Image
Adhérent AIDUCE n°189 / Membre UBV-BDB n°87

Avatar du membre
davidoff
Cirrocumulus
Cirrocumulus
Messages : 890
Enregistré le : dim. 29 sept. 2013, 18:03
Genre : Homme

Re: Proteus, le GG électronique (par Imeo)

Message par davidoff » dim. 22 mai 2022, 09:34

Salut ! Je viens d’en trouver un d’occaz et en passant par ici, je me demande si quelqu’un peut m’expliquer la mise en route du chipset avec du fil stainless. Sait-on jamais !

Avatar du membre
davidoff
Cirrocumulus
Cirrocumulus
Messages : 890
Enregistré le : dim. 29 sept. 2013, 18:03
Genre : Homme

Re: Proteus, le GG électronique (par Imeo)

Message par davidoff » dim. 27 nov. 2022, 19:37

Up!

Quikouiou
Stratus
Stratus
Messages : 3
Enregistré le : ven. 1 juin 2012, 12:05
Genre : Non spécifié

Re: Proteus, le GG électronique (par Imeo)

Message par Quikouiou » dim. 4 déc. 2022, 01:55

PROTEUS IS IN YOUR HANDS:
1. Battery Installation: Unscrew the venting cap and insert an 14500 IMR battery with
the negative side up and in an angle to avoid damage the electronic part. Screw the
venting cap back in. If the battery fails to make contact, unscrew again the venting
cap and adjust the small brass bolt inside.
2. Lock Proteus: After installing the battery, wait six (6) seconds until Proteus locks. A
GREEN light will blink several times followed by a BLUE light which stays on for
two (2) seconds. Proteus is now locked.
3. Attach an Atomizer: Connect an atomizer (equipped with a Titanium Grade 1 Coil)
to Proteus.
4. Detect Configuration: Press the button five (5) times in quick succession. A BLUE
light will blink three (3) times, indicating that your Proteus is now unlocked, followed
by the RED light thats blinks while the Proteus is detecting your configuration.
Proteus has detected your configuration once the light turns ORANGE and remains on
for two (2) seconds. This process can take from one (1) minute to three (3) minutes
depending on the temperature of your atomizer.
5. Vape: You're ready to go! Push the button to vape!
LIGHTS THAT WILL APPEAR DURING VAPING:
One (1) short RED blink: Proteus hasnt reached yet the desired temperature because
the battery cannot sustain the set temperature level.
Ten (10) fast GREEN blinks: Your atomizer is fed badly or is running out of liquid.
On GG atomizers, opening the liquid control may resolve the problem. If the problem
persists, you probably have to refill your atomizer.
Continuous slow LIGHT BLUE blinks: The battery's charge is getting low. Either
change your battery or consider moving to a lower temperature to prolong battery life.
Also, the continuous slow LIGHT BLUE blinks may occur because of bad connection
between your battery and Proteus's cap or because of dirty threads. Please raise the
small brass bolt inside the cap or clean the treads of Proteus.
Five (5) slow WHITE blinks: The battery is discharged. Proteus stops functioning.
Steady BLUE light for two (2) seconds: Proteus is locked because the button was
depressed for more than fifteen (15) seconds or because the electronic got too hot
(thats an extremely rare situation). To unlock Proteus, press the button five (5) times
in quick succession.
Ten (10) fast RED blinks: Your atomizer has a lower resistance than Proteus can
handle or your atomizer is shorting. Check your atomizer or make a new coil. Before
you make a new coil, wash your atomizer under running water to remove any small
pieces of wire that remain from your previous coil set up, which may be shorting it. In
rare situations, the 10 fast red blinks may appear if the current that goes to atomizer is
more than VIR's limit (8,8 ampere).
Steady ORANGE light for three (3) seconds: Your battery is damaged. Please dont
use it anymore and recycle it in the proper way.
MENU:
Note: The working temperature range is 180-280 degrees Celsius. Proteus remembers
all your settings after the battery has been changed.
Up Menu - Increase Temperature: Push the button three (3) times and keep the button
depressed for one (1) second. The RED light will stay on. While the RED light is on,
push the button one (1) time to increase the temperature by ten (10) degrees Celsius,
two (2) times to increase by twenty (20) degrees Celsius, and so on...
Down Menu - Decrease Temperature: Push the button four (4) times and keep the
button depressed for one (1) second. The GREEN light will stay on. While the
GREEN light is on, push the button one (1) time to decrease the temperature by ten
(10) degrees Celsius, two (2) times to decrease by twenty (20) degrees Celsius, and so
on...
Lock Proteus: Push the button five (5) times. A BLUE light will stay on for two (2)
seconds, indicating that your Proteus is now locked.
Unlock Proteus: Push the button five (5) times. A BLUE light will blink three (3)
times, indicating that your Proteus is now unlocked.
Check Set Temperature: Go to either the Up or Down Menus and, when either the
RED or GREEN lights turn on, release the button. An ORANGE light will start
blinking slowly, each blink indicating one step in temperature. Each step is ten (10)
degrees Celsius. The total number of blinks will let you know what temperature you
are at. One blink indicates 180 degrees Celsius. Two blinks indicates 190 degrees
Celsius, and so on...
Stop LED's from Blinking: Push the button one (1) time.
CHANGING THE ATOMIZER:
If you want to vape again on the same atomizer (without changing the coil), lock
Proteus and then disconnect the atomizer. Reconnect this atomizer when you are
ready, unlock Proteus, and vape! If you forget to lock Proteus before disconnect the
atomizer, the green light will blink to inform you that you forgot to lock Proteus. You
have 6 seconds to lock it before Proteus lose your settings.
If you want to vape with a different atomizer (or change the coil in existing atomizer),
disconnect your OLD atomizer and let Proteus lock by itself (The green light will
blink for 6 seconds and then the blue light will stay on for 2 seconds). Now connect
the NEW atomizer and unlock Proteus. Wait for it to detect your configuration.
Proteus will blink red while detecting your configuration and the process will finish
when an ORANGE light remains on for two (2) seconds. This may take from one (1)
to three (3) minutes depending on the temperature of your atomizer. You're ready to
vape again!
VERY IMPORTANT TIPS AND TRICKS:
Please operate Proteus up to 230 Celsius degrees to have a decent battery life.
Especially on GG atomizers (Penelopes), you can gain more battery life by NOT
opening a lot the liquid control.
Keep threads and contacts clean, otherwise your Proteus will not work as you expect.
The threads of the coil must NOT touch each other.
The legs of the coil (the distance between coil and posts that keep wires) should be the
shortest possible OR covered by wick.
The wick should be loose when tucked between the resistance coils.
Keep all your electrical connections tight.
If you see that green light blinks more often than usual on a new wick, dont worry.
Please give wick some time to be saturated.
The last step of temperature (280 Celsius degrees) is very strong. So green light will
blink more often that the other steps to prevent a burned wick.
If Proteus gets stuck, release the connection to the battery, wait 3 seconds and
reconnect the battery. You will not loose any of your settings.
Proteus checks per time to time your configuration, so when this procedure starts
please dont interrupt it. You will be ready to vape again when the orange light stays on
for two (2) seconds.
Range of Ti wires sizes that are recommended for atomizers which will go on Proteus:
0,20 mm - 0,50 mm
OTHER SPECIFICATIONS OF THE ELECTRONIC PART:
1. Atomizer detection.
2. Working atomizer check.
3. Battery check.
4. Lock Mode.
5. 15 seconds cut-off.
6. Short circuit protection.
7. Reverse battery protection.
8. Over-discharge battery protection.
9. Thermal monitoring.
10. Atomizer doesn't work at all when you go from one menu to another, something
that saves battery and also doesn't annoy the user.
11. It works with 1x3,7 volt battery, with 2x3,7 volt batteries and with 2x3 volt
batteries.
12. Remembers your last set up.
13. 8,8 ampere upper limit.
14. 8 volts upper limit.
15. Resistance range: 0,45-1,35 ohms.
16. The shortest and thinnest electronic PCBA today.
17. It goes on and off its tube like a mobile card (no wires anywhere).
18. Totally mechanical button. There is no electronic button on the PCBA.
19. Five colour led.
20. Battery autobalance: Proteus vapes without new adjustments even if battery is
down to 3,45 volts.
21. you know when you run out of liquid
22. it vapes the same way in all environments (very hot - very cold).
23. you know when battery is low or out of charge.
24. The maximum power of the electronic is 30watts.

Avatar du membre
davidoff
Cirrocumulus
Cirrocumulus
Messages : 890
Enregistré le : dim. 29 sept. 2013, 18:03
Genre : Homme

Re: Proteus, le GG électronique (par Imeo)

Message par davidoff » lun. 5 déc. 2022, 08:02

3. Attach an Atomizer: Connect an atomizer (equipped with a Titanium Grade 1 Coil)
C’est à partir de là que je décroche ! 😂 Non, mais ne souhaite pas utiliser du fil titane pour le coil, et je sais que c’est possible de le faire fonctionner en stainless. Un peu compliqué donc et si quelqu’un pouvait me montrer la manip…

Répondre

Retourner vers « Les mods électroniques »